Bosch MUC 2 RU Series Instruction Manual page 13

4� Press button G to start the preparation
programme.
The appliance heats up the pan until the
target temperature is reached. During the
heating phase, lines that light up in a clock-
wise direction appear in the display.
Once the target temperature is reached,
the lines go out and the preparation time
is shown in the display. The preparation
process starts automatically.
Note: when the programme [ паста ] (pasta)
or [ фритюр ] ( deep frying) is selected, a
repeating audible signal is emitted, the
display and button G flash until the food
has been added and button G has been
pressed.
The preparation time counts down.
Steam that is formed when preparing the
meals exits the multi cooker via the steam
outlet, thereby preventing the formation of
excess pressure. Depending on the model,
the steam outlet is fitted with a viewing
window.
Increasing or reducing the temperature
If the current temperature was set too high
or too low during the preparation, this can
be increased (by +10°C max.) or decreased
(by -10°C max.) accordingly during the
cooking process.
MUC_2-4_RU_8001013355.indb 11
To increase the temperature, press and
hold the C button. The current temperature
will briefly be shown on the display and will
then increase in 1°C increments until the
maximum value is reached (+10°C). Press
and hold the button until the temperature is
at the increased level desired.
To reduce the temperature, press and hold
the C button. The current temperature will
briefly be shown on the display and will
initially increase in 1°C increments until the
maximum value is reached (+10°C). Once
the maximum value has been reached, the
display will jump back to the minimum value
(20°C lower).
Press and hold the button until the tempera-
ture is at the reduced level desired.
To continue with the preparation
programme,.press the G button.
Note: If the G button is not pressed, the
preparation programme will continue with
the temperature that was previously set.
When the preparation programme ends,
an audible signal sounds and the indicator
[ готово ] (ready) and button G light up. The
display flashes and shows "00:00".
5� Open the lid of the appliance and serve
the meal that has been prepared.
W Warning
Risk of burns!
■ During preparation, large amounts of
steam may accumulate in the appliance.
Open the lid with care. Do not lean over
the lid of the appliance.
■ The pan and any inserts that are used
may be very hot. Always use pan tongs,
corresponding handles or oven gloves.
Notes:
■ The preparation programme can be
stopped at any time using button H.
The appliance subsequently switches to
function selection mode.
■ If the preparation programme features
the keep warm function, this is switched
on automatically once the meal is ready
and keeps the meal warm for up to
10 hours at 40°C. [ готово ] (ready) and
Operation en
11
10.08.2015 12:44:52