Pairing Product And Mobile Device - Silvercrest SMSZ 1 A1 Operation And Safety Notes

˜ Pairing product and mobile
device
NOTES:
Screenshots are from the iOS 13 .3 app version
(if not otherwise marked) . Older iOS versions
may have functional limitations .
The Android version of the app follows the
same principles as the iOS version; you might
encounter discrepancies between the two
platforms, such as slightly different on-screen
commands or icons .
Updating the firmware might result in changes
to the app's functionality .
An updated instruction manual can be found
here:
{Me}
tab:
{User Manual} .
Tap
Preparation
Install Lidl Home app and setup Gateway
( Gateway instruction manual) .
D
9 ] [
1 . Pull protective strip
compartment (fig . D) .
7 ] [
out of battery
9 ] [
If already mounted: Remove product from wall
bracket .
[ 12 ]
2 . Wait until flashing red LED
warm-up phase of approx . 30 s .
3 . After the warm-up phase has ended, the
product switches to test mode . If the movement
of a human body is detected in test mode,
a notification will be sent to the user as a
reminder . After 20 minutes, the product
automatically switches to power saving mode .
NOTES:
If the movement of a human body is detected
in power saving mode, a notification will be
sent to the user as a reminder . If a human body
is permanently moving within the detection
area, this will not be registered as multiple
motions . If no movement has been detected
in the detection area for at least 1 minute, the
product will start again to detect movements of
a human body .
If you want to switch to test mode, remove the
battery from the battery compartment and
reinsert it .
goes off after a
[ 5 ]
GB/IE/NI/MT/CY 11