Table of Contents
Advertisement
DOK-SUPPL*-VSP*XX.3***-IT01-EN-P
Rexroth IndraControl VSP xx.3 Panel PC
10.2
Mounting
Loss of degree of protection IP 65!
The housing, into which the panel PC is installed, has to fulfill the following
conditions:
● free from impurities
● sufficient mechanical strength and flatness
These criteria influence the required degree of protection IP to a great ex‐
tent.
Further required measures are to be taken depending on the mounting lo‐
cation, e. g. the stabilization of the mounting frame.
For mounting the panel PC proceed as follows:
1. Create a mounting cut-out with 8 holes, diameter 5 mm, according to the illustra‐
tions "Mounting dimensions" on the following pages.
2. Remove the paper strip from the seal on the rear side of the front panel.
3. Insert the panel PC from the front into the cut-out. The M4 mounting bolts have to
be inserted into the drilled holes.
4. Fasten the panel PC by screwing the nuts at the rear side of the mounting bolts.
Mounting, Dismounting and Electrical Installation
Bosch Rexroth AG
23/43
Advertisement
Table of Contents
