Cable Routing - Yamaha YZF-R1 2003 Supplementary Service Manual

CABLE ROUTING

1 Headlight drain plug
A Make sure to securely insert the
coupler and boot.
B The headlight lead can be routed
by either of the headlight or the
boss. Do not catch the headlight
lead when assembling the front
cowling.
C Do not make the lead stretch too
much.
D Secure the junction of the cord
headlight at the place of white
tape.
CABLE ROUTING
E Secure the inner side of the junc-
tion part of the head light sub
wire harness (including the head
light lead and auxiliary light lead)
behind the pawl of the head light
body with the clamp.
F To turn signal light.
G To main harness.
H Route the junction of the head-
light, position lamp and turn sig-
nal light leads through the pawl
on the headlight body. (Pay
attention to the direction.)
–2–
SPEC
I Insert the headlight relay to the
rib of the headlight body. (No
special order is specified for right
and left.)
J Route the headlight lead behind
the cap of headlight breather
hole. (It can be routed below, but
should not be in front of the cap.)
K To the auxiliary light lead.
L To meter assembly
M To headlight relay