Silvercrest SHBS 500 D4 Operating Instructions Manual page 102

3) Set the cutting length to the desired hair length on the comb attachment
0/q. To do this, press the button on the back of the comb attach-
ment 0/q and push the comb attachment 0/q upwards or down-
wards (see fig. 3). You can read the cutting lengths via the markings
on the comb attachment 0/q (see fig. 4). Start with a longer cutting
length and reduce this in stages while cutting the hair.
NOTE
Press the button, when you push the comb attachment 0/q upwards
►
or downwards (see fig. 5). This makes it easier to release the comb
attachment 0/q from the catch and move it.
Fig. 4
4) Start the haircut at the back of neck or sides and cut towards the
middle of the head. Then cut the front part of the hair towards the
middle of the head.
5) Hold the appliance so that the comb attachment 0/q is as flat as
possible against your head. Guide the appliance evenly through the
hair and only in one direction to prevent hair from getting caught in
the shaving head 1.
6) Where possible, cut against the direction of hair growth.
SHBS 500 D4
Fig. 5
GB│MT
│
99 ■