Download Print this page

Toro 07167 Installation Instructions Manual

Electric lift kit for workman gtx

Advertisement

Quick Links

Electric Lift Kit
Workman
Model No. 07167—Serial No. 404400001 and Up
Model No. 07168—Serial No. 404400001 and Up
Important:
You must install this kit in conjunction with the Extended Bed Kit (Toro Model No. 07149).
Important:
When you have the Electric Lift Kit installed on the extended bed, do not exceed 181 kg
(400 lb) when lifting a centered load; otherwise damage may occur.
If you center the load toward the front of the cargo bed, the lift capacity decreases.
Important:
When installing the Electric Lift Kit, use an overhead hoist to raise the extended cargo bed
(Figure
1).
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
GTX Utility Vehicle with Extended Bed
Figure 1
Register at www.Toro.com.
Form No. 3430-702 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *3430-702* A
Printed in the USA
g037510

Advertisement

loading

Summary of Contents for Toro 07167

  • Page 1 Model No. 07168—Serial No. 404400001 and Up Installation Instructions Important: You must install this kit in conjunction with the Extended Bed Kit (Toro Model No. 07149). Important: When you have the Electric Lift Kit installed on the extended bed, do not exceed 181 kg (400 lb) when lifting a centered load;...
  • Page 2: Preparing The Machine

    Preparing the Machine Park the machine on a level surface. Engage the parking brake. Shut off the engine and remove the key. g038563...
  • Page 3 Installing the Lift Bracket Important: The extended cargo bed is removed from the figure for clarity; do not remove the extended cargo bed. Remove the existing bolt and nut from the rear-frame tube. Note: Discard the bolt and nut. Remove the 2 existing plastic rivets from the rear-frame tube. Note: Retain the 2 plastic rivets.
  • Page 4 Installing the Actuator Stop Electric Machine Only Install the actuator stop to the battery tray mounting bracket using the bolt and nut. g037512 Electric Machine Shown...
  • Page 5: Installing The Fuse

    Installing the Fuse For Machines with Serial Number 403446000 and Before Install the 15A fuse into the fuse block. g281197 Gasoline Machine Shown on Top; Electric Machine Shown on Bottom...
  • Page 6 For Machines with Serial Number 403446001 and After Install the 15A fuse into the fuse block. g281196 Gasoline Machine Shown on Top; Electric Machine Shown on Bottom...
  • Page 7: Installing The Switch

    Installing the Switch Remove the plastic cover from the dashboard. Note: Discard the plastic cover. Install the switch connector through the opening in the dashboard. Install the switch to the switch connector. Ensure that the switch is oriented properly. g037514...
  • Page 8 Installing the Lift Cylinder Important: Use the cable tie to secure the lift-cylinder wire to the wire harness, away from sharp or moving parts. Ensure that you allow enough slack in the wire harness for its full range of motion. Install the lift cylinder using a clevis pin and hairpin cotter.
  • Page 9 Important: Use a block to support the lift cylinder so that it extends upward at a 45° angle. g038792...
  • Page 10: Operation

    Operation WARNING Driving the machine with the cargo box raised may cause the machine to tip or roll easier. The box structure may become damaged if you operate the machine with the box raised. • Operate the machine only when the cargo box is down. •...
  • Page 11 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
  • Page 12 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact your Authorized Toro Service Center.

This manual is also suitable for:

07168