Powering On The Projector; Powering Off The Projector - Panasonic PT-TW331RU Operating Instructions Manual

Powering On the Projector

Before switching on the projector, make sure all the other devices are correctly connected (
1 ) Connect the power plug to the power outlet.
Enter Standby status when the <ON(G)/STANDBY(R)> indicator is lighting / blinking in red.
z
2 ) Press the < v / b > button on the control panel or the remote control.
When the <ON(G)/STANDBY(R)> indicator lights up in green, the lamp is on.
z
Startup screen is displayed for about 10 seconds, then the image will be projected.
z
Note
If the power is disconnected due to the power breaker during projection at the last use,
z
indicator will light in green automatically at the next startup and the image will be projected.

Powering Off the Projector

1 ) Press the < v / b > button on the control panel or the remote control.
The following message appears.
z
Message will disappear after about 30 seconds when there is no operation.
z
2 ) Press the < v / b > button again.
The projection stops and the <ON(G)/STANDBY(R)> indicator on the projector flashes up in red. (Fan is
z
still spinning.)
3 ) Wait until the <ON(G)/STANDBY(R)> indicator lights / blinks in red (The fans stop
spinning).
The projector enters standby mode when the <ON(G)/STANDBY(R)> indicator lights / blinks in red.
z
Note
Do not turn on the power and project images immediately after turning the projector off. Turning on the power while the
z
lamp is still hot may shorten the lamp life.
Make sure that the projector is cool enough if you want to pack it for transportation and storage.
z
OR
Powering ON/OFF
pages 27-28).
Æ
the <ON(G)/STANDBY(R)>
ENGLISH -
31