Panasonic PT-TW331RU Operating Instructions Manual page 58

Maintenance/replacement
Lamp unit
J
The lamp unit is a consumable component. See "When to replace the lamp unit" about the lifespan.
It is recommended to ask an authorized engineer to replace the lamp unit. Contact your dealer.
Consult your dealer to purchase a replacement lamp unit: ET-LAL341.
CAUTION:
■ Do not replace the lamp unit when it is hot. (Wait at least 1 hour after use.)
The inside of the cover can become very hot, take care to avoid burn injuries.
Notes on the replacement of the lamp unit
J
The luminous source of the lamp is made of glass and may burst if you hit it against a hard surface or drop
z
it. Please handle with care.
A Phillips screwdriver is required for replacement of the lamp unit.
z
Be careful of hands slip when you using a screwdriver.
z
When replacing the lamp unit, be sure to hold it by the handle.
z
When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be
z
broken. If replacing the lamp of a projector which has been installed on the ceiling, you should always
assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it.
Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces
of glass get into your eyes or mouth, seek medical advice immediately.
The lamp contains mercury. Consult your local municipality or your dealer about correct disposal of used
z
lamp units.
Attention
Be sure to use the lamp unit specified.
z
Note
The part numbers of accessories and separately sold components are subject to change without notice.
z
When to replace the lamp unit
J
The lamp unit is a consumable component. Brightness decreases according to duration of usage, so
periodical replacement of the lamp unit is necessary. The estimated duration before replacement is 3 000
hours. However, this may be shortened depending on individual lamp characteristics, usage conditions, and
the installation environment. Therefore, it is strongly recommended that a replacement lamp unit be prepared.
When the projection lamp of the projector reaches its end of life, the warning message appears on the screen.
Replace the lamp with a new one promptly.
Model name
PT-TW331RU
PT-TX301RU
Attention
If [Lamp Life Reminder] is set to [Off], the lamp warning message will not be displayed when the lamp used time reaches
z
the end of lamp life. In this case, please check the lamp life with the values at the [Lamp Hours Used (Normal)] and [Lamp
Hours Used (ECO)]. (
Note
The usage period of 3 000 hours is a rough estimate and is not guaranteed.
z
The used lamp time is calculated internally in the following formula as the used time in each setting of [Normal], [AUTO],
z
[ECO1] and [ECO2] in [Lamp power mode]:
Lamp runtime = (Lamp runtime of [Normal] × 60 + Lamp runtime of [AUTO] × 24 + Lamp runtime of [ECO1] or [ECO2] ×
In order to estimate the lamp life, please refer to [Lamp Hours Used (Normal)] and [Lamp Hours used (ECO)] in the [Lamp
z
Æ
settings] menu (
modes. Please note that they are not displayed individually.
58
- ENGLISH
Lamp runtime
If the lamp is used over 2 970 hours, the warning message will
Over 2 970 hours
appear. When any button is pressed, the message will disappear.
Æ
page 45)
45) ÷ 60
page 45). [Lamp Hours Used (ECO)] is a total real time under [AUTO], [ECO1] and [ECO2] lamp power
On screen:Warning Lamp message