Erasing Shadows Around The Edges; Of A Copy (Erase Copy) - Sharp AR-5618 Operation Manual

COPY FUNCTIONS
ERASING SHADOWS AROUND THE EDGES OF A
COPY
(Erase Copy)
● This feature is used to erase shadows that appear around the edges of copies of books and other thick originals.
(EDGE ERASE)
● The feature can also erase the shadow that appears down the centre of books and other originals that open up.
(CENTRE ERASE)
● The factory default setting for the width of the erasure is approximately 10 mm (1/2"). The width can be changed
in the system settings.
EDGE ERASE
Original
CENTRE ERASE
Original
• Centre erase cannot be used in combination with dual page copy.
Note
• Erase copy cannot be used in combination with 2 IN 1 / 4 IN 1 copy.
• Erase copy cannot be used when the paper is a special size or copying from the bypass tray.
• Note that if the width of the erasure is too large, the edge of the image may be partially erased.
1
Place the original(s).
2
If the original is placed on the
document glass, select the original
size. (p.27)
When using the SPF/RSPF, make sure that the
same ORIGINAL SIZE indicator as your original
size lights up.
3
Press the [ERASE] key (
select the desired erase mode.
46
(p.71)
Copy
Copy
(p.27)
/ ) to
To select the "EDGE +
CENTRE ERASE" mode,
press the [ERASE] key
( / )
until both the EDGE
( ) and CENTRE
indicators ( ) light
up.
EDGE + CENTRE ERASE
Original
(p.43)
4
Set the number of copies and other
settings, and then press the [START]
key ( ).
The copy is delivered to the paper output tray.
• To cancel erase copy, press the [ERASE]
Note
key ( /
ERASE indicators (
off.
• If the original size was not selected in step
2, erase copy cannot be used.
Copy
) repeatedly until the
/ ) are both