Connecting Projectors; Setting Up Set B - Hitachi CP-WU5500 User Manual

2.3 Installing the second projector (Set B)

Connecting projectors

To use Intellectual Stack, connect an RS-232C cross cable between the CONTROL
port of Set A and Set B.

Setting up Set B

1.
Turn on Set B.
• After turning on Set B, make sure the image of Set B is not
NOTE
signifi cantly tilted compared to the image of Set A. If the image is overly tilted,
rotate the elevator feet of Set B to adjust the angle such that the tilt is just
about right.
2.
Reset the adjustment of KEYSTONE and PERFECT FIT on Set B.
(Operating Guide
• KEYSTONE, PERFECT FIT, or WARPING function cannot be used
NOTE
at the same time. Please use an appropriate function.
• Perform the INSTALLATION setting fi rst if necessary as it may change the
image position.
(continued on next page)
→ EASY MENU
(Operating Guide
or SETUP menu)
→ SETUP menu)
Installation
11