Selecting Lamp Operation Mode - Hitachi CP-WU5500 User Manual

3.3 Selecting lamp operation mode

Select the DUAL or ALTERNATE lamp operation mode.
1.
Highlight LAMP MODE in the STACK menu with
the ▲/▼ buttons, then press the ► button to
display the LAMP MODE dialog.
2.
Use the ▲/▼ buttons in the dialog to highlight DUAL or ALTERNATE.
DUAL: Turns on the projectors at the same time.
ALTERNATE: Turns on the projectors alternately.
3.
Press the ◄ button to return to the previous menu, or press the ► button to
complete the setting. ( 24 )
NOTE • If DUAL is selected, a menu to select MAIN or SUB appears on screen
when a button on the control panel of the projector or remote control is pressed.
Select the projector that you want to operate. Refer to the examples below.
- When the MENU button is pressed, a menu to select MAIN or SUB is displayed.
If MAIN is selected, EASY MENU or ADVANCED MENU of the Main projector
is displayed.
- When the GEOMETRY button is pressed, a menu to select MAIN or SUB is
displayed. If MAIN is selected, GEOMETRY CORRECTION menu of the Main
projector is displayed.
• When DUAL is selected for
LAMP MODE, there are operating
restrictions as follows.
- AUTO POWER OFF and
FREEZE functions on both
projectors are disabled.
- It takes slightly longer time to turn
on the projectors. This is not a
malfunction.
• There are cases in which the screen
will be darker when any of the OSDs
are displayed if DUAL is selected.
• The screen may be darker when any
of the OSDs are displayed in PbyP or
PinP display because one of the
two projectors displays the black screen.
(continued on next page)

Menu to select
MAIN or SUB
Menu to select
MAIN or SUB
STACK menu settings
Menu on Main projector

Menu on Main projector
19