Download Print this page

Connecting Peripheral Devices - Fujitsu PRIMERGY RX200 S2 Quick Start Manual

Hide thumbs Also See for PRIMERGY RX200 S2:

Pull out the slide rails until they click.

When pulling out the slide rails, pull out the item A

(inside of the both slide rails) to the front of the slide

rails until it stops.

Install the server in the rack cabinet.

1. Insert the inner rail to the grooves of the

slide rail and slide the server towards the

back.

2. Hold the locks on the right and left pulled,

slide the server even further and install it

into the rack.

��

When sliding the server backward, always keep the

slide rails and inner rails on both sides in a horizon-

tal position.

Connecting peripheral devices

Peripheral devices, such as the keyboard and mouse, etc., are connected to the server in the following

order.

�

��

�

- Be careful not to pinch your fingers or catch any

clothing when sliding the server into the cabinet.

This could cause injury.

- For the first time installation, make sure to slide the

server backward and fix it to the rack securely.

Fasten the server to the rack.

Install the attached blank panel to the rack, where

the server or peripheral devices are not installed.

��

�

��

Table of Contents