Advertisement
8
Turning off the power and installing optional devices
Install optional devices to be installed after the OS installation, such as UPS device.
������������
"Chapter 7 Installing Internal Options"
1
Check that no medium is inserted in
the floppy disk drive or CD-ROM drive.
2
Exit the operating system (OS).
After the OS is exited, the server is automatically
turned off.
When the power of the server is not off after the OS
is exited, press the power switch on the front of the
server.
3
Power off the peripheral devices, such
as the display.
4
Install the optional devices.
9
Hints for error handling
In preparation of a failure occurring, set the fol-
lowing.
������������
"Chapter 5 Operations after OS
Installation"
- Set to collect memory dump
If the memory dump is set, debugging information is au-
tomatically saved when the STOP error occurs in the sys-
tem. This helps to analyze the cause of error occurrence.
- Create a system restoration disk
When the system file or system environments are dam-
aged, the system can be reconstructed with the content
saved in the system restoration disk.
- Store system settings
By storing the BIOS settings, the original information can
be recovered when the setting information is lost.
When this server is installed, store and save the BIOS set-
tings by yourself. Be careful not to lose the stored BIOS
setting information as you must provide this when you
contact an office listed in the "Contact Information".
When the settings are completed, make sure to
check notes before operation.
������������
"5.5 Note before Operating the Server"
For details about maintenance after operations have
started, refer to "User's Guide Chapter 9 Operating
and Maintenance".
After optional devices are installed, set the BIOS
setup utility or SCSI setup utility as necessary.
For details about setting procedures, refer to the
"User's Guide Chapter 8 Hardware Configuration/
Utilities" and "PRIMERGY RX200 S2 Onboard
SCSI RAID User's Guide".
When turning on the server again after turning it
off, wait for at least ten seconds and then press the
power switch.
If the server is turned on straight after being turned
off, an error will occur that may cause damage.
10
Support and Service
lPRIMERGY information
The latest PRIMERGY, driver, and software information is
available at the address below. Use as necessary.
http://primergy.fujitsu.com
lBefore requesting repairs
If an error occurs in this server, refer to "User's Guide 9.2
Troubleshooting". If problems can still not be solved, con-
tact an office listed in the "Contact Information".
When contacting the office listed in the "Contact Informa-
tion", inform them of the product ID and a manufactures
number which are detailed on labels on the base of the
server.
Also read the points to note about requesting repairs before-
hand in "User's Guide 9.9.2 Contacting Maintenance Sup-
port".
Print the "Configuration Sheets" - "Accident sheet" and en-
ter the checked information.
Be careful not to lose this sheet, as you must provide this
information when you contact an office listed in the "Con-
tact Information".
6
�����������
��������������
������
Advertisement
