Table of Contents
Advertisement
3
Installation
Refer to the nearest Authorised Service Agent for installation of the product. To make the product ready for use, review the information in the
user manual and take care that the electricity, tap water supply and water drainage systems are appropriate before calling the Authorized Service
Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out.
DANGER
B
¾ Have the installation and electrical connections of the product made by the Authorized Service Agent.
Manufacturer shall not be held liable for damages that may arise from procedures carried out by
unauthorized persons.
DANGER
¾ Product The weight of your product is not suitable to be carried by one person.
CAUTION
A
¾ Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged
products cause risks for your safety.
CAUTION
A
¾ Preparation of the location and electrical, tap water and waste water installations at the place of installation are
under customer's responsibility.
¾ Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed
while pushing the product into its place after installation or cleaning procedures.
3.1 Appropriate installation location
• Place the machine on a rigid floor. Do not place it on a long pile rug or similar surfaces.
• Do not place the product on the power cable.
• Do not install the product at places where temperature may fall below 0ºC. (See, Warnings for drying)
• Place the product at least 1.5 cm away from the edges of other furniture.
• There should not be any lockable, sliding or hinged door that may restrain the loading door to open fully in the installation place of this
product.
• Operate the product in a well-ventilated and dust-free environment.
3.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.
DANGER
¾ The product is heavy. Remove the packaging reinforcement as illustrated.
¾ Pay attention not to squeeze your hand under the machine during this procedure.
3.3 Removing the transportation locks
CAUTION
A
¾ Do not remove the transportation locks before taking out the packaging reinforcement.
¾ Remove the transportation safety bolts before operating the washing machine! Otherwise, the product will be
damaged.
User's Manual
7 / EN
Hide quick links:
Advertisement
Table of Contents
