Air Handling Parts; Air Guide And Blower; Fan - LG LWC1031DAG Manual

2.2 AIR HANDLING PARTS

2.2.1 AIR GUIDE AND BLOWER

1. Remove the front grille. (Refer to section 2.1.1)
2. Remove the cabinet. (Refer to section 2.1.2)
3. Remove the control box. (Refer to section 2.1.3)
4. Remove the 4 screws which fasten the brace.
5. Remove the brace.
6. Remove the 2 screws which fasten the evaporator.
7. Move the evaporator forward and pulling it upward
slightly. (See Figure 4)
8. Move the evaporator to the left carefully.
9. Remove the 2 terminals carefully. (See Figure 5, at
Electric heater Model)
10. Remove the 3 screws which fasten the Heater
Cover. (See Figure 5, at Electric Heater Model)
11. Remove the Heater cover. (See Figure 5, at
Electric Heater Model)
12. Pull out the hook of orifice by pushing the tabs
and remove it. (See Figure 6)
13. Remove the clamp with a hand plier which
secures the blower.
14. Remove the blower.
15. Remove the 4 screws which fasten the air guide
from the barrier.
16. Move the air guide backward, pulling out from the
base pan.
17. Re-install the components by referring to the
removal procedure, above.

2.2.2 FAN

1. Remove the cabinet. (Refer to section 2.1.2)
2. Remove the brace (Refer to section 2.2.1)
3. Remove the 4 screws which fasten the condenser.
4. Move the condenser to the left carefully.
5. Remove the clamp which secures the fan.
6. Remove the fan. (See Figure 7)
7. Re-install by referring to the removal procedure.
Copyright ©2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Figure 4
Figure 5
Figure 6
Figure 7
- 7 -
4 5
3 6
2 7 Off
Med
Fan
8 High
1 Coo l
9
Th erm
os tat
Low
Fan
Med
Low Coo l
Op era Coo l
tio n
LGE Internal Use Only