Advertisement
Quick Links
Hitch Frame Kit
for Workman HD/HDX/HDX-D Series Utility Vehicle
Model No. 07377—Serial No. 290000001 and Up
Safety
Safety and Instructional
Decals
Safety decals and instructions are easily
visible to the operator and are located
near any area of potential danger.
Replace any decal that is damaged or
lost.
115-2047
1. Warning—do not touch the hot surface.
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Installation
1. If a 2/3 or Full Size Bed is installed on vehicle, it
must be removed as follows:
A. With bed lowered, remove clevis pins and lynch
pins securing each cylinder rod end to bed
mounting plates (Figure 1).
1. Bed mounting plate
2. Cylinder rod end
B. Remove clevis pin and two lynch pins securing
each set of pivot plates to frame channels
(Figure 2).
1. Vehicle frame channel
2. Pivot plate
Register at www.Toro.com.
Form No. 3361-381 Rev A
Installation Instructions
Figure 1
2/3 Bed Shown
3. Clevis pin
4. Lynch pin
Figure 2
Full Bed Shown
3. Clevis pin
4. Lynch pin
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 07377
Summary of Contents for Toro 07377
- Page 1 Form No. 3361-381 Rev A Hitch Frame Kit for Workman HD/HDX/HDX-D Series Utility Vehicle Model No. 07377—Serial No. 290000001 and Up Installation Instructions Safety Installation 1. If a 2/3 or Full Size Bed is installed on vehicle, it Safety and Instructional...
- Page 2 C. Carefully remove the bed from the vehicle. 5. Loosely secure an attachment bracket to each engine frame mounting bracket and vehicle frame with two flange head capscrews and flange locknuts previously removed (Figure 4). The full bed weighs approximately 325 lb (147.5 6.
- Page 3 Figure 7 Full Bed Shown Figure 10 Full Bed Shown 1. Left rear corner of bed 2. Pivot bracket 10. Loosely mount each set of new rear pivot plates to right and left bed frame channels with three 3/8 x 3-3/4 inch large capscrews and locknuts (Figure 8).
- Page 4 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfi ed with your Distributor’s service or have diffi...