Panasonic NR-B32FX3 Service Manual page 33

a. Insert deeply each wire one by one in Scotch Lock.
• Scotch lock is a parts that can connect with non-
stripped wires. No need to strip wire beforehand.
When stripped wire is connected with scotch lock, it
will come off.
b. The lid (color painted) of the Scotch Lock is caulked
with pliers. Then the lid height become in the same of
the body height of the Scotch Lock.
• When scotch lock is caulked with pliers, be sure to
caulk while pushing lead wires towards back side.
Otherwise an electric circuit will not be connected
properly.
c. After caulking with pliers 2 or 3 times, check if it is
fixed by pulling lead wires.
CAUTION
Be careful not to be bite the wires by Sensor PC
Cover, when store the wires and the Scotch Lock in it.
11.2. Disassembly of VC (Vegetable
Compartment)
11.2.1. PCB (VC)
1. Remove Crisper A'ssy and Plate Crisper
• Pull Crisper Case, take it out from each two portions of
Rail VC right and left.
• Pull Plate Crisper from upper side in VC.
-You can see the figure (11.2.2.(1)).
2. Remove the screw that is fixation of Cover LED on upper
side of VC. Then remove Cover LED.
3. Remove PCB (VC) while pressing left and right hooks of
reverse side of Cover LED.
4. Pull the connector out while pressing the hook.
NOTES
• Be careful not to break PCB (VC) when it is removed and
installed.
11.2.2. CRISPER A'SSY and Plate Crisper
1. Remove Crisper A'ssy and Plate Crisper.
• Pull Crisper Case, take it out from each two portions of
Rail VC right and left.
• Pull Plate Crisper from upper side in VC.
33