Panasonic NR-B32FX3 Service Manual page 41

11.8. The Door Setting Exchange Work Manual
This appliance is setting right side opening door when it is shipped from the factory. However you can change the door setting to left
side opening to exchange those parts as below. You can exchange those parts to refer to the work manual below.
TO PREPARE AND TO CONFIRM FOR THE WORK
1. Confirm the parts
Confirm whether there are those parts below or not.
(Bundled Parts)
(The matter of importance)
• When you install an important hinge with the torque
restriction, tighten by a torque wrench after it fixes with a
plus screwdriver temporarily.
• There is a possibility of damaging screw when strongly
tightening too much.
2. Remove trays and shelves of reverse side of Door A'ssy
PC.
Remove trays and shelves of reverse side of Door A'ssy
PC, to prevent the trays and shelves from cracking and
breaking. (When there is some foods on reverse side of
the door, it is necessary to take foods out. When you do
not take foods out, the floor might be made dirty with the
dropping foods.)
3. Unplug the refrigerator
Unplug the refrigerator before work for your safety.
NOTICE
• After the power is turned off, the temperature of each com-
partments rise.
THE POINTS OF WORK
11.8.1. Remove Door A'ssy PC
1. Remove Cover Hinge Top R
a. Remove screw that is fixation of Cover Hinge Top R.
b. Pry off five Hooks (triangle mark part) of Cover Hinge
Top R by screwdriver (-), then remove Cover Hinge
Top R.
2. Remove Cover Table L.
• Remove Cover Table L in the same way above.
3. Remove Hinge Top R
a. Pull the connector from connector storage part, then
pull the connector out while pressing the hook to
upper side.
41