Connecting To The Drain - Beko 2012 CXY User Manual

• The water supply pressure required
to run the machine must be 1-10 bar
(0,1 – 1,0 MPa). Attach a pressure-
reducing valve if the water pressure
is higher.
• Connect the special hoses supplied
with the machine to the water intake
valves on the machine. The hose
bearing the "red" sign (90°C max)
is the hot water inlet and the hose
bearing the "blue" sign (25°C max) is
for the cold water inlet.
• If you are going to use your double
water-inlet machine as a single (cold)
water-inlet unit, you must install the
stopper*, supplied with your machine
to the hot water valve.
If you want to use both water inlets
of the product, you can connect the
hot water hose after removing the
stopper and gasket group from the
hot water valve.
* Applies for the products supplied
with a blind stopper group.
• Open the taps completely after
making the hose connection to
check if there is any water leakage
at the connection points. Turn off
the tap and remove the nut in case
of any leakage. Retighten the nut
carefully after checking the seal.
To prevent any water leakage and
any other damage to be caused by
it, keep the taps closed when the
machine is not in use.
• Models with a single water inlet
should not be connected to the hot
water tap. Laundry may be damaged
or the appliance may switch to
protection mode and not work.
When returning the appliance to its
place after maintenance or cleaning,
care should be taken not to fold,
squeeze or block the hoses.

Connecting to the drain

The water discharge hose can be
attached to the edge of a washbasin or
bathtub. The drain hose should be firmly
fitted into the drain as to not loosen in
its housing.
Important:
• The end of the drain hose can be
directly connected to the wastewater
drain or to the washbasin. The
fitting must be secured in all types
of connections. Your house may be
flooded if the hose falls out of its
housing during water discharging.
• The hose should be attached to a
height of at least 40 cm, and 100 cm
at most.
• In case the hose is elevated
9
EN