Table of Contents
Advertisement
✿✤✦✪✤✧Z✮_✥.❇m ✤✦
Date and Time
"
" flashes on the base unit display if the clock has not been
set. Set the clock by following the steps below.
1
Press [MENU] .
2
Scroll to " Date and time " by pressing [ ] or
[ ] , then press Select .
3
Enter 2 digits each for month, day, and
1
year.
(e.g. To set Apr. 7, 2003, enter "04 07 03".)
Enter 4 digits for time (hour and minute).
2
(e.g. To set 9:30, enter "0930".)
• If you enter a wrong number, press [ ] or [ ] to
move the cursor to the incorrect number. Enter the
correct number.
4
Select " AM " or " PM " by pressing AM/PM .
5
Press Save , then press [OFF] .
• The clock is set and "
base unit.
• If 3 beeps sound after pressing Save , the setting
is not correct. Try again from step 3.
• When entering the time in step 3, you cannot enter numbers greater than 12. Do
not use military time. (To set 13:00 hours, enter "0100", then select " PM " in
step 4.)
• When the display language is set to French, you can use military time (see
page 13 of the French Operating Instructions).
If a power failure occurs, the time setting may be incorrect. When "
on the base unit display, adjust the date/time.
To check the date/time, repeat steps 1 and 2 above.
• The current date/time is displayed. When finished, press [OFF] .
For Call Display service users (p. 28)
• Caller information will reset the clock after the first ring if the adjusted time is
incorrect.
• If the time has not previously been set, caller information will not adjust the
clock.
• Caller information will automatically adjust the clock for daylight saving time.
]
]
Programmable Functions
Handset
" disappears from the
_
Date and time
Exit
Select
Date:12.31.2003
1
Time:12:00 AM
AM/PM
Save
Example
Date:04.07.2003
0
Time:09:30 AM
AM/PM
Save
Date:04.07.2003
0
Time:09:30 AM
AM/PM
Save
" flashes
13
Advertisement
Table of Contents
