Table of Contents
Advertisement
✿✤✦✪✤✧Z✮_✩.❇m 5✩
Troubleshooting
Cordless Telephone
Problem
" No link to base.
Place on cradle and
try again. " is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
The handset does not ring.
The handset display is blank.
You cannot program function
items.
While programming or
searching, the unit starts to
ring and stops the program/
search.
You cannot make a call with
the handset.
You cannot redial.
56
]
]
Cause & Remedy
• You are too far from the base unit. Walk closer
and try again.
• Place the handset on the base unit and try
again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
• Move the handset and the base unit away
from other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• Select a clearer channel (p. 25, 38, 46).
• The ringer volume is set to OFF. Set to HIGH,
MEDIUM or LOW (p. 18).
• Charge the battery fully (p. 9).
• Programming is not possible while the unit is
being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• A call is coming in. To answer the call, press
[
] or [
] . Try again from the beginning
after hanging up.
• Your handset is in remote operation mode
(p. 46). Exit by pressing [OFF] .
• If the last number dialed was more than
32 digits long, the number will not be redialed
correctly.
_
Advertisement
Table of Contents
