Running A Product Check - Epson l300 User Manual

Light status
The power light is on or
flashing
The ink light is flashing
The paper light is flashing
The ink light is on
The paper light is on
The power light is flashing
The ink light is flashing
The paper light is flashing
Parent topic:
Related references
Paper Jam Problems
Where to Get Help
Related tasks
Refilling the Ink Tanks
Related topics
Loading Paper

Running a Product Check

Running a product check helps you determine if your product is operating properly.
1. Press the
2. Disconnect any interface cables connected to your product.
3. Load plain paper in the product.
4. Hold down the
5. When the product turns on, release both buttons.
The product begins printing a nozzle check pattern.
Condition/solution
The ink pads are near the end of their service life. Contact Epson for
support.
An error has occurred during firmware updating. Connect your product
using a USB cable and try updating the firmware again. If the error
message continues, contact Epson for support.
A fatal error has occurred. Turn the product off and then back on again.
If the error continues, check for a paper jam. If the error persists,
contact Epson for support.
Solving Problems
power button to turn the product off.
stop button and press the power button to turn the product on.
82