Fuse; Headlights - Toro 71202 Operator's Manual

Fuse

Service Interval/Specification
The electrical system is protected by a fuse. It
requires no maintenance, however if the fuse blows
the starter will not crank. To replace the fuse pull up
on the fuse (Fig. 17) to remove or replace it.
Fuse: 7.5 amp, blade-type
Figure 17
1. Fuse (removed)

Headlights

Specification: Bulb # 1156
Removing the Bulb
1. Disengage the blade control (PTO), shift into
neutral, set the parking brake, and turn the
ignition key to "OFF" to stop the engine.
2. Open the hood. Pull wire connectors off both
bulb holder terminals.
3. Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Fig. 18).
4. Push and rotate the bulb counterclockwise until
it stops (approx. 1/4 turn) and remove bulb from
the bulb holder (Fig. 19).
1
5
3
2
4
Figure 18
1. Bulb holder
2. Reflector
3. Tabs
Installing the Bulb
1. The bulb has metal pins on the side of its base.
Align the pins with the slots in the bulb holder
and insert the base into the holder (Fig. 19).
Push and rotate the bulb clockwise until it stops.
2
4
3
Figure 19
1. Bulb
2. Metal pins
2. The bulb holder has two tabs (Fig. 18). Align the
tabs with the slots in the reflector, insert the bulb
holder into the reflector and rotate it 1/4 turn
clockwise until it stops.
3. Push the wire connectors onto the terminals on
the bulb holder.
Maintenance
5
1
4
4. Slots
5. Terminals
1
2
4
3. Bulb holder
4. Slots
21