Table of Contents
Advertisement
6. Clean around the fill plug (Fig. 28) so that dirt cannot
fall into the reservoir if fluid needs to be added.
1
m-4983
Figure 28
1. Fill plug
7. Remove the fill plug and check the fluid level.
Note: The level should be a maximum of 1-1/4 in. (32 mm)
below the top of the fill port (Fig. 28). Add oil if necessary.
8. Install the fill plug.
Servicing the Fuse
The electrical system is protected by fuses. No maintenance
is required; however, if a fuse blows, check the circuit
wiring for a short. To replace a fuse, pull up (Fig. 29) to
remove it from the socket. Push down to insert it.
Fuses: 10 amp, blade-type
Figure 29
1. Fuse (removed)
1-1/4 in. max.
(32 mm)
1
2
m-1672
2. Socket
27
Servicing the Headlights
Use a #1156, automotive-type bulb.
Removing the Bulb
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Open the hood. Pull the wire connectors off of both of
the bulb holder terminals.
6. Rotate the bulb holder 1/4 turn counterclockwise and
remove it from the reflector (Fig. 30).
5
3
2
4
Figure 30
1. Bulb holder
2. Reflector
3. Tabs
7. Push and rotate the bulb counterclockwise until it stops
(approximately 1/4 turn) and remove the bulb from the
bulb holder (Fig. 31).
Installing the Bulb
1. The bulb has metal pins on the side of its base. Align
the pins with the slots in the bulb holder and insert the
base into the holder (Fig. 31). Push and rotate the bulb
clockwise until it stops.
5
1
4
m-1874
4. Slots
5. Terminals
Advertisement
Table of Contents
