Advertisement
Installation
Placement location
ER74232HK
ER74253HK
ER74333HK
ER74357HK
9
This appliance has been designed for home use only. It cannot
be installed on yachts or in caravans.
Do not place the gas hob in the bathroom, bedroom, basement,
corrosive material in close proximity.
Do not place flammable or explosive objects on or around the
gas hob, e.g. curtains.
The distance between the side walls and the back wall with
the edge of the gas hob should be at least 100mm and 50mm
respectively. Otherwise if there are flammable materials around
the gas hob, e.g. wooden wall and plastic wall etc, then the gas
hob should be installed at a distance of at least 150mm to the
side wall and 100mm to the back wall.
The distance between the hob to the flammable ceiling should
be 1m, otherwise there is no limit.
The use of the gas hob will result in temperature rising and
humidity increasing in the room where the hob is installed.
Therefore, please ensure there are good ventilation openings.
If the gas hob operates at a high flame for a long time , then
good ventilation is required. To accomplish this ventilation, you
may open a window, door, or use an efficient range hood with
an exhaust fan.
Installing the gas hob over other appliances such as oven,
steam oven and microwave etc should be according to the
requirements specified in the manufacturer's manual to ensure
it meets the ventilation requirement.
If a drawer is installed under the hob, it is recommended to use
a non-flammable intermediate support to isolate the objects
stored in the drawer from circulating air coming from the hob's
ventilation system. Please do not put any heat-sensitive or
flammable products under the drawers, which include spraying
agent or shoes polishing.
If the gas hob is installed in a cupboard, the plastic cooking
and adhesive bonded panel in it should be subjected to the
fire-resistant glue treatment (heat resistant glue); otherwise,
deformation or scaling of the surface-layers will likely result,
especially on the sides of the cupboard.
The gas hob should be installed on a solid, flat worktop. The
minimum thickness of the worktop should be 16mm and the
depth should be more than 550mm.
The cupboard should have a tapping size which meets the
ventilation requirements and is open to the air. The stove
ventilation pipe opening should be a minimum of 100cm
Otherwise , the lack of ventilation might cause an explosion
resulting from the leakage of gas.
.
2
Advertisement
