Table of Contents
Advertisement
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
The cooking zones do not oper-
ate.
You cannot activate or operate
the oven. The display shows
"400" and an acoustic signal
sounds.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.
The display shows "12.00".
www.zanussi.com
The back lamp
1. Turn the lamp glass cover counterclockwise
2. Clean the glass cover.
3. Replace the oven lamp with a suitable 300
4. Install the glass cover.
Possible cause
Refer to the operating instructions for the built-in cooking surface.
The oven is incorrectly connec-
ted to an electrical supply.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven for
too long.
There was a power cut.
The lamp glass cover is at the back
of the cavity.
to remove it.
°C heat-resistant oven lamp.
Use the same oven lamp type.
Check if the oven is correctly
connected to the electrical sup-
ply (refer to the connection dia-
gram if available).
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
Reset the clock.
Remedy
17
Advertisement
Table of Contents
