Table of Contents
Advertisement
The mounting holes are configured for a single-
gang electrical box or a round ceiling electrical
box. See page 26 for the mounting hole
diagram. The housing can also be mounted to
any flat surface.
Step 3.1 -
Step 3.2 -
Once the mounting location has
been selected, determine if the
video and the power input wires
should enter the housing through
either the side or the bottom. For
ease of re-assembly, this step
should be performed in conjunction
with Section 2, Input Power
Connections.
Disconnect the Input Power wires
from the terminal block on the
Voltage Regulator Board (VRB).
Unplug the BNC section of the
Video Output cable.
11
Advertisement
Table of Contents
