Table of Contents
Advertisement
Step 3.3 -
Step 3.4 -
Step 3.5 -
Step 3.6 -
For side wiring entry, feed the
power and video cables through a
½ NPT nipple (not supplied) or an
electrical conduit and connect them
as per Figure 3-1 on page 13.
Tighten the nipple into the side of
the base. Seal the wiring conduit
with silicone to prevent moisture
penetration.
For bottom wiring entry, feed the
wires through the hole in the base
and connect them as per Figure 3-2
on page 14. Close the side hole with
the supplied ½ NPT plug.
Mount the camera base. A mounting
hole template has been provided on
page 26 for this procedure.
Seal all holes in the neoprene pad
and around the ½ NPT plug with
silicone to prevent moisture
penetration.
12
Advertisement
Table of Contents
