Troubleshooting - D-Link AirPlus DI-614+ Manual

Troubleshooting

This chapter provides solutions to problems that can occur during the installation and
operation of the DI-614+ Wireless Access Point. We cover various aspects of the
network setup, including the network adapters. Please read the following if you are
having problems.
(Note: It is recommended that you use an Ethernet connection to configure the DI-614+
1. The computer used to configure the DI-614+ cannot access the
Configuration menu.



Note: The IP Address of the DI-614+ is 192.168.0.1. All the computers on the network
must have a unique IP Address in the same range, e.g., 192.168.0.x. and a Subnet Mask
of 255.255.255.0. Any computers that have identical IP Addresses will not be visible on the
network.

Check that the Ethernet LED on the DI-614+ is ON. If the LED is not
ON, check that the cable for the Ethernet connection is securely
inserted.
Check that the Ethernet Adapter is working properly. Please see
item 6 (Check that the drivers for the network adapters are installed
properly) in this Troubleshooting section to check that the drivers are
loaded properly.
Check that the IP Address is in the same range and subnet as the
DI-614+. Please see Checking the IP Address in Windows XP in the
Networking Basics section of this manual.
Do a Ping test to make sure that the DI-614+ is responding. Go to
Start>Run>Type Command>Type ping 192.168.0.1. A successful ping
will show four replies.
Access Point.)
50