Dynamic Ip Address For Wan - D-Link DSL-G604T User Manual

Dynamic IP Address for WAN

Follow the instructions below to configure the Router to use a Dynamic IP Address for the Internet connection.
Make sure you have all the necessary information before
you configure the WAN connection.
1. The ATM VC Settings at the top of the menu
should not be changed unless you have been
instructed to change them. However, if you are
instructed to change the VPI or VCI values,
type in the values assigned for your account.
Leave the PVC and Virtual Circuit settings at
their default (Pcv0 and Enabled) values for
now. These can be used later if you are
configuring multiple virtual circuits for your
ADSL service.
2. Under Dynamic IP section, choose the
Connection Type from the pull-down menu.
For Dynamic IP mode connections the available
encapsulation methods are 1483 Bridged IP
LLC and 1483 Bridged IP VC-Mux.
3. Some ISP's may require you to use the original
computer that was originally registered for the
Internet service. In this case, type in the MAC
address of the computer that was used. To
obtain the MAC address of the computer, you
can do the following.
4.
For Windows XP/2000: Start → Run → cmd → OK
In the command prompt, type in ipconfig/all. The physical Address is the MAC address of the computer.
For Windows ME: Start → Run → command → OK
In the command prompt, type in ipconfig/all. The physical Address is the MAC address of the computer.
5. If you have not been instructed to change the ATM settings at the bottom of the menu, leave these at the
default settings. If you have been given new settings to configure, select the Service Category and type
in the values for PCR and VCI in Kbps.