Add Read-Only Access To An Interface; Enable Snmp Access To An Interface - D-Link DFL-1100 User Manual

Add Read-only access to an interface

To add read-only access, click on the interface you would like to add it to. Note that if you
only have read-only access enabled on an interface, all users will only have read-only access,
even if they are administrators.
Follow these steps to add read-only access to an interface.
Step 1. Click on the interface you would like to add it to.
Step 2. Enable the Read-only checkbox.
Step 3. Specify which network addresses should be allowed read-only access to the
interface, for example 192.168.1.0/24 for a whole class C network or 172.16.0.1 –
172.16.0.10 for a range of IP addresses.
Step 4. Specify protocol to be used to access the DFL-1100 via the dropdown menu.
Select HTTP and HTTPS (Secure HTTP) or HTTPS only.
Click the Apply button below to apply the settings or click Cancel to discard changes.
Example:

Enable SNMP access to an interface

Follow these steps to add read-only SNMP access to an interface.
Step 1. Click on the interface you would like to add it to.
Step 2. Enable the Read-only checkbox.
Step 3. Specify which network addresses should be allowed to receive SNMP traps, for
example 192.168.1.0/24 for a whole class C network or 172.16.0.1 – 172.16.0.10 for a
range of IP addresses.
Step 4. Specify the community string used to authenticate the DFL-1100.
Click the Apply button below to apply the settings or click Cancel to discard changes.
Example:
14