D-Link Air DWL-900AP User Manual page 20

USB Configuration Utility (continued)
Note: Once you have assigned or obtained an IP Address for the DWL-
900AP, through the USB Configuration Utility, we recommend that you
manage your network using the SNMP Utility (please refer to the chapter
in this manual entitled "SNMP Management Utility".) If you choose to
manage your network using the USB Utility, you will need to connect the
DWL-900AP to a computer on your network, using the USB cable, each
time you have a management session on your network.
5. Change the IP settings of the access point. You may elect to use a
DHCP server to determine the IP settings, or set them according to
the requirements of your IP addressing scheme.
To configure the device as a DHCP client, select Enable from the DHCP
Client: pull-down menu.
To manually assign the IP settings, you must Disable the DHCP client
function and set the IP address and subnet mask. If necessary, you can
assign a Gateway IP address for the device here as well.
20