D-Link Air DWL-900AP User Manual page 32

SNMP Utility Menus (continued)
IP Address
The Internet Protocol address of the Access Point
Subnet mask
Four sets of three digits used to logically divide an IP network into sub-
networks.
Gateway
The IP address of a gateway device necessary for communication with
devices outside the subnet of the Access Point. If your network is not divided
into different subnets, this can remain blank.
DHCP
The Access Point can be configured as a DHCP client by choosing Enabled
in the DHCP enable pull-down menu. By default DHCP support is Disabled.
If the Access Point is configured as a DHCP client, it will be necessary to
decide what media will be used to transport DHCP information to the device.
By default the Access Point is configured to receive IP settings through the
Ethernet port. If your network is set up so that DHCP services are supplied
through the wireless LAN, you must change the Primary port: setting to
Wireless in the pull-down menu and click Apply to put the change into
effect.
Click Refresh to refresh the screen to list the most current settings.
32