D-Link Xtreme G DWL-G520 Quick Installation Manual page 9

G. SSID: The Service Set
Identifier is the name as-
signed to the wireless
network. The factory SSID
setting is set to default. Make
changes here to match the
SSID on existing Wireless
Router or Access Point.
G
H
J
K
J. TxRate: You can adjust the
transmission rate to get the best
signal possible depending on
your usage and your environment.
H. Wireless Mode:
The factory setting is
set to Infrastructure.
Ad-Hoc mode is used
for peer-to-peer
networking.
I
K. Power Mode: By default, Power Mode is set
to Continuous Access Mode. Continuous
Access Mode — this default setting con-
sumes the most power. Maximum Power
Save — this setting consumes the least
power. Power Save — this setting consumes
a moderate amount of power.
9
I. Channel: By default, the
channel is set to 6. Channel
selection is automatically
adjusted by the DWL-G520
depending on the channel
setting of the access point
selected for association. To
change the channel settings,
the Wireless Mode must be
set to Ad-hoc.