Advertisement
Do Not operate the drill if any parts are missing or the drill is damaged as this may cause failure and/or possible personal injury.
8
Do Not operate the drill when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
Do Not abuse the cord. never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil,
8
sharp edges or moving parts. damaged or entangled cords increase the risk of electric shock.
Avoid body contact with earthed or grounded surfaces such as pipes, radiators,ranges and refrigerators. There is an increased risk
9
of electric shock if your body is earthed or grounded.
Use the power tool, accessories and tool bits etc. in accordance with these instructions and in the manner intended for the
9
particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for
operations different from intended could result in hazardous situation.
Avoid accidental starting. Ensure the switch is in the off position before plugging in. Carrying power tools with your finger on the
9
switch or plugging in power tools that have the switch on invites accidents.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier
9
to control.
Store all safety notes and safety instructions for future reference. The term power tool in all of the warnings listed below refers to
9
your mains operated (corded) power tool or battery operated (cordless) power tool.
2. iNtRoDuCtioN
Powerful rotary hammer drill with SDS Plus chuck. Three drilling functions. Safety clutch system. Supplied in storage case with 8mm, 10mm
and 12mm masonry drill bits, pin and cold chisels and PVC dust cap. Fitted with 360° auxiliary handle.
3. SPeCifiCatioN
model No: ......................................................... SDSPluS26
Chuck Type: ............................................................SdS Plus
Concrete drilling diameter: ......................................... 26 mm
Impact energy: ................................................................ 4.2J
Impact Rate: ........................................................... 4300 bpm
no load Speed: ........................................................ 880 rpm
noise Power: .................................................. 106 dB(A) LWA
noise Pressure: ................................................95 dB(A) LPA
drilling Capacity: ....................................................................
Concrete: .................................................................... 26 mm
4. oPeRatioN
fig.1
4.1.
auxiliaRy HaNDle
4.1.1.
Push the auxiliary handle over the drill chuck and onto the locating ring and then tighten it by turning the handle.
4.2.
iNSeRtiNG SDS BitS aND CHiSelS
4.2.1.
Remove the plug from the socket.
4.2.2.
draw back the SdS drill chuck to the end stop.
4.2.3.
Insert the bit or chisel to the chuck.
4.2.4.
Release the outside of the SdS drill chuck.
4.2.5.
It should only be possible to move the bit or chisel in the drill chuck by approximately 1 cm forwards or backwards.
© Jack Sealey limited
Original Language Version
SDSPLUS26 Issue 1 24/09/19
Advertisement
