Advertisement
fig.2
4.3.
oN/off SWitCH (fiG.1)
4.3.1.
The hammer drill is started by pressing the on/off switch.
4.3.2.
Release the on/off switch to switch it off.
4.4.
DRilliNG/HammeR DRilliNG
4.4.1.
By shifting the selection switch 2 (fig.1) to position (A) or (B), you can select the drilling or hammer drilling function.
4.4.2.
Setting drilling: A+C
4.4.3.
Setting Hammer Drilling: B+C
4.4.4.
Setting Chiselling: B+D
fig.3
4.5.
RotatioN StoP oN/off
4.5.1.
For drilling, always set the selection switch 1 (fig.1) to (C).
4.5.2.
For chiselling, always set the selection switch 1 (fig.1) to (D) That way, rotation is deactivated.
4.6.
DuSt PRoteCtioN attaCHmeNt
WaRNiNG! Wear approved safety eye protection with side shields and a dust mask if drilling generates dust.
‰
4.6.1.
Use the dust protection cap when drilling overhead, to collect the dust from drilling.
4.6.2.
Put the dust cap on the tool.
4.6.3.
Put the tool into the SdS drill chuck.
5. maiNteNaNCe
5.1.
CleaNiNG
WHat?
Clean the ventilation slots of the motor to remove dust.
Clean the device.
▲
DaNGeR! Unprofessional repairs may mean that your unit will no longer operate safely. This endangers you and your environment.
If you are unable to eliminate the error yourself, please contact your local Sealey stockist directly. Please remember that repairs
carried out by non-professionals will invalidate your warranty claim and may cause additional costs.
eRRoR/fault
Tool holder does not turn.
no hammer drilling function.
no chasing function.
5.2.
If the tool has decreased performance, have the unit serviced and the carbon brushes replaced by a qualified service technician.
© Jack Sealey limited
HoW?
Use a vacuum, cleaning brush or paint brush.
Wipe the unit with a damp cloth.
CauSe
no power supply.
Is the device defective.
Selection switch is not set correctly.
Original Language Version
RemeDy
Check the cable, plug, and the fuse.
Contact your local Sealey stockist.
Put the switch to position
Set the switch to position
SDSPLUS26 Issue 1 24/09/19
Advertisement
