Advertisement
fig.9
fig.11
16. sprAYGUN mAiNteNANce
For optimUm perFormANce it is verY importANt to eNsUre the sprAY GUN is correctlY cleANed AFter
eAch Use.
disconnect from the air supply before attempting any cleaning or maintenance.
16.1.
cleANiNG the GUN
16.1.1.
Flush the gun through with clean solvent.
16.1.2.
Use a bristle brush and solvent to wash off accumulated paint.
16.1.3.
Clean the air nozzle using a brush. Blow clean with air. Handle all nozzles carefully and do not make any alterations in the gun.
16.1.4.
Wipe the outside of the gun with a dampened solvent rag.
16.1.5.
If there is a need to probe the holes in the nozzles, ensure a tool that is softer than brass is utilised, under no circumstances use a
metal tool, as the slightest amount of damage will adversely affect the spray pattern.
16.1.6.
Adjust the fluid needle valve so that when the gun is triggered, air flow occurs before fluid flow.
16.2.
mAiNteNANce
16.2.1.
Take care when re-assembling. Screw parts hand tight to avoid cross-threading. If a part cannot easily be turned by hand, check
that it is the correct part, or unscrew it, realign and retry. do Not use excessive force when re-assembling.
16.2.2.
When changing the nozzle size, ensure the complete nozzle set is fitted. This consists of air cap, fluid nozzle and paint needle.
Insert the fluid nozzle before paint needle.
17. tYre iNFlAtor operAtioN
17.1.
AttAch AdAptor to vAlve
Push and hold the connector onto the tyre valve, squeeze the thumb clip on the connector, push the connector onto the tyre valve and
release the clip.
The connector will now be locked in place.
17.2.
to iNFlAte
Momentarily depress the operation lever fully, then release to display tyre pressure. When reading the pressure, hold the gauge "flat"
with respect to the eye to minimise error.
Fully depress operation lever for an appropriate period. Avoid over inflation, release lever frequently to check the pressure.
Weee reGUlAtioNs
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
eNviroNmeNt protectioN
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey Group, Kempson Way, suffolk Business park, Bury st edmunds, suffolk. ip32 7Ar
01284 757500
© Jack Sealey limited
fig.10
fig.12
01284 703534
sales@sealey.co.uk
Original Language Version
fig.13
www.sealey.co.uk
SAC5020E.V3, SAC5020EPK.V2 Issue 1
13/06/19
Advertisement
