Advertisement
At the back of the dispenser there is a red switch which controls the heating power, and a
green switch controlling the cooling power.
You can turn it on when you need hot or cold water.
When you rst turn on the switch, for optimal temperature, the dispenser will need around 20
minutes for hot water and around an hour for cold water.
3 Instruction
· Unpack the water dispenser. Place the dispenser indoors, on a at surface and at a distance
no less than 15 cm from the back wall.
· Insert the bottle vertically on the seat
· Press the hot water button until water ows out from the faucet.
· Insert the power plug to the wall socket.
· Turn on the power switch on the back of the unit to heat or cool the water. The indicator light
will be on when heating or cooling is working. To get optimal temperature, do not turn o the
power switch until heating or cooling is done.
· Enjoy the hot or cold water you need.
· If you do not need hot or cold water, turn o the power switch to conserve energy.
4 Precautions
· The drain plug on the back of the unit may become loose during shipping. Fasten the drain
plug tightly before you start to operate the unit. If the drain plug is loose, the unit may leak
and cause oor damage.
· Make sure to have poured water from the water faucet before plugging and switching the
appliance ON to heat. If the dispenser is turned ON with an empty water tank, it can be
damaged.
· When you are ready to move the water dispenser, do not tilt more than 45º to avoid damage
to the compressor.
· Keep this appliance away from high temperatures and in a dry and ventilated place.
Never install it in the open air or under rain or direct sunlight.
3
Cooling switch
Power Switch
Heating switch
Advertisement
