Optical Drive; Removing The Hard-Drive And Optical-Drive Bracket - Dell OptiPlex 5090 Service Manual

Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card slot.
2. Slide the solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3) that secures the solid-state drive to the system board.
Next steps
1. Install the 2.5/3.5-inch hard-drive
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in

Optical drive

Removing the hard-drive and optical-drive bracket

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5/3.5-inch hard-drive
About this task
The following images indicate the location of the hard-drive and optical-drive bracket and provide a visual representation of the
removal procedure.
caddy.
after working inside your
before working inside your
caddy.
computer.
computer.
Removing and installing components 27