Test Connection - Toro Tempus Air BW User Manual

Toro Tempus Air BW
Step 4
TM
LoRa

TEST CONNECTION

If the association of the modules is carried out before the final installation of the Tempus Air BW, this connection
test can be used to validate the positioning of the latter by going to temporarily install the Tempus Air BW in its
intended location then by going to position a module in each of the valve boxes to verify good communication
with the Tempus Air BW. The connection test can also allow you to verify at any time the correct operation of the
TM
LoRa radio between your module and the Tempus Air BW.
(Example: the product fell into the upside-down valve box and no longer communicates with the Tempus Air
BW). To test the LoRa
1. Enter the Tempus Air
module in Bluetooth®
If the connection is not established, a "No connection established" message appears. Repeat this test several
times to confirm that the connection cannot be made. In this case, the distance between the Tempus Air BW
and the Tempus Air module will need to be reduced.
6
TM
connection, do the following:
Then in the parameters
(small pencil at the top right)
3. Push the red
button to test the
connection LoRa
TM
2. Push on « Remote access »
4. The message indicate
TM
that the LoRa
between the Tempus Air BW
and the module is reliable
connection
.