Table of Contents
Advertisement
CCU | User Manual
3 Agreed Product Use
The intended and non-intended use of iTraMS CCU
product is discussed in the below sections.
3.1 Intended Use
RBEI will be responsible for delivered products being fit for
use of purpose intended and/or having a defined level of
quality, such responsibilities are subject to the application
of the product conforming to the agreed upon environment,
installation and stress conditions, as such are referenced
in the attached specification.
When the product during the Bosch release procedures
has successfully met the testing specifications agreed to
the Customer, it is deemed to fully cover all requirements,
if any, that the product be fit for the use or purpose
intended and/or have a defined level of quality. Customer
shall be responsible for the system application, which
includes ensuring that the intended product application
and all environmental, installation and stress conditions to
which the product will be exposed are covered by such
testing. Customer shall be responsible for making sure
that the product will not be exposed to conditions in
excess of those referenced in such testing specifications.
The
conditions
of
use
installation and loads) contained in this manual and
associated agreed documents constitute the scope of the
product's suitability for its contractually required, intended
or ordinary use and the scope of the product's condition/
quality. The customer is responsible for ensuring the
product's usability in the vehicle.
The product is intended for and is undergoing approval for
installation and operation in automobiles, commercial
vehicles, off-highway vehicles and coaches with a rated
voltage of 12(24) volts. It may be necessary to adapt the
product's factory-set state to suit the specific country.
Only connecting cables and external devices that are
appropriate for the device in question as regards safety,
electromagnetic compatibility and grade of shielding may
be used. Compliance with the applicable standards cannot
be guaranteed if the device is modified without the
agreement of Bosch.
Bosch is only responsible for implementing the device
side connector (interface) according to the customer's
specifications.
Bosch
responsibility and does not provide any guarantee for
the plug-in connection – in particular for its electrical
functioning, durability and imperviousness – since this is
Robert Bosch Engineering and Business Solutions Private Limited | September 19, 2020
(environment,
application,
does
not
assume
any
applied by request of the customer.
If, in order to connect the device, ignition and battery are
bridged, the device will draw the full operating current
even when switched off. In this case, without any further
deactivation on the vehicle-side, there is a risk of battery
depletion. No liability is assumed for any damage
occurring because of this. Do not cover ventilation
openings and heat sinks – otherwise a build-up of heat
may occur in the device that could lead to malfunction.
There are no specific ventilation openings or heat sinks
in CCU device, but mounting in a thermal capsuled
environment should be avoided, as it will lead to an
increase of the operating temperature.
Do not insert foreign bodies in the insertion slots or
openings of the device – otherwise injury or damage to
the device may occur.
The device must not be exposed to hot or burning
objects (e.g. cigarettes).
To clean the device, never use hard or sharp objects that
could damage the protective pane or housing. Do not
use aggressive cleaning agents such as thinners,
benzene, abrasive cleaners, spray cleaners, acidic or
alkaline solutions, or wax. Do not spray any liquids onto
the device. To clean the housing and protective pane /
display, moisten a soft cloth with tepid water and wipe
off the dirt. Make sure that no liquid enters the inside of
the display. Afterwards, wipe the cleaned surface with a
clean, dry cloth.
If the device is to be cleaned before installation in the
vehicle, make sure the openings (in particular the
connector contact points) are kept sealed so that no
liquid can enter the device.
7 | 20
Advertisement
Table of Contents
