Table of Contents
Advertisement
FZDA07ELEF2/EREF2/MRHF2
● Description of operations
1
Title
2
Tx TEST title
3
Frequency
4
Packet type
5
Parameter frame
A
Shift to "Engineering Diag Menu (Page2)" screen.
∗ Menu key is toned down whenever any one of SWs
displayed on the screen is pressed for one time.
F
Run the Tx test.
G
Run the Rx test.
H
Reset test results.
I
Increase frequency.
J
Decrease frequency.
K
Display the preceding packet type.
L
Display the succeeding packet type.
M
Start the test mode.
In Rx testing or Tx testing, use UP/DOWN key to tone down.
Do not tone down with the setup value.
∗ After operating SW on this screen, turn on or off ACC (ACC
OFF/ON) in order to reboot the navigation.
■ Reset Position screen
1
Reset Position
Please press the 'Reset' button to reset the vehicle
position to the current map default.
● Description of operations
1
Title
2
Texts
A
Reset present position to the default setup.
(Oversea model) This button shall always be able to
be pressed regardless of the navigation disc.
B
Shift to "Engineering Diag Menu (Page2)" screen.
34
TEST MODE
2
B
Menu
Reset
A
■ Engineering Diag Menu (Page3) screen
B
S e r v i c e 3
N ex t
C
Connection Info.
Audio Diag Menu
D
E
Vehicle Signal Info.
● Description of operations
1
Title
B
Shift to "Engineering Diag Menu (Page4)" screen.
C
Return to NAVI map screen. (If the map DISK is not
inserted, the Caution screen is shown.)
D
Shift to "Audio Diag Menu" screen.
E
Shift to "Vehicle Signal Info." screen.
H
Shift to "Touch Panel Adjust (Page1)" screen.
I
Shift to "Touch Panel Check" screen.
J
Shift to "Hard Switch Check" screen.
K
Shift to "Speed Pulse Check" screen.
L
Shift to "Rear Camera Check" screen.
■ Connection Info. screen
• Connection status of externally connected equipment is
displayed.
• Connection status of speaker can be checked.
∗ When the equipment is connected it is shown in blue and
when not connected it is shown in red.
1
Connection Info.
2
• MIC
Connect
3
• AUX
Connect
4
• RearCamera Connect
5
• ETC
Connect
• VICS
Connect
6
• TMC
NC
7
• TEL
NC
10
● Description of operations
1
Title
2
Display connection status of the MIC unit.
3
Display connection status of the AUX unit.
4
Display connection status of the Rear Camera unit.
5
Display connection status of the ETC unit. (Only in
Japan model)
6
Display connection status of the VICS antenna. (Only
in Japan model)
1
Touch Panel Adjust
Touch Panel Check
Hard Switch Check
Speed Pulse Check
RearCamera Check
A
Menu
• TV Antenna
Connect
• DCM
Connect
• DC Offset Detection
Undetection
Clear
H
I
J
K
L
8
11
9
C
Hide quick links:
Advertisement
Table of Contents
