Panasonic WH-MDC09G3E5 Service Manual page 3

Item
Starting Current
Running Current
Maximum Current For Mono Bloc Unit
Power Factor
Power factor means total figure of compressor and outdoor fan motor.
Power Cord
Thermostat
Protection Device
Item
Performance Test Condition
Operation Range
Internal Pressure Differential
Water Pipe Diameter
Water Drain Hose Inner Diameter
Pump
Hot Water Coil
Pressure Relief Valve Water Circuit
Flow Switch
Protection Device
Expansion Vessel
Capacity of Integrated Electric Heater
Note:

Cooling capacities are based on outdoor air temperature of 35°C Dry Bulb with controlled water inlet temperature
of 12°C and water outlet temperature of 7°C.

Heating capacities are based on outdoor air temperature of 7°C Dry Bulb (44.6°F Dry Bulb), 6°C Wet Bulb
(42.8°F Wet Bulb) with controlled water inlet temperature of 30°C and water outlet temperature of 35°C.

Specification are subjected to change without prior notice for further improvement.
Number of core
Length
Outdoor Ambient
Water Outlet
Inlet
Outlet
Motor Type
No. of Speed
Input Power
Type
No. of Plates
Size (H × W × L)
Water Flow Rate
Volume
MWP
Unit
A
Cooling: 13.0
A
Heating: 9.9
A
Cooling: 96
%
Heating: 95
m (ft)
Unit
°C
°C
kPa
mm (inch)
mm (inch)
mm (inch)
W
mm
3
l/min (m /h)
kPa
A
I
bar
kW
8
Mono Bloc Unit
13.0
Heating: 10.8
22.9
-
-
Electronic Control
Electronic Control
Water System
EN 14511
Cooling: 16 ~ 43
Heating: -20 ~ 35
Cooling: 5 ~ 20
Heating: 25 ~ 55
Cooling: 36.5
Heating: 57.5
30 (1-3/16)
30 (1-3/16)
15.00 (19/32)
DC Motor
7 (software selection)
84
Brazed Plate
48
82 × 93 × 325
Cooling: 20.0 (1.2)
Heating: 25.8 (1.6)
Open: 300, Close: 265 and below
Magnetic Lead Switch
Residual Current Circuit Breaker (40)
6
3
3.00
Cooling: -
Cooling: -
Heating: 95