Advertisement
8.6.4. Place the roof panel with ridge beam attached onto one side of the shed and slide it up the gable ends
until it is in position. Ensure that the top lip of the gable ends sits neatly into the channeling on either side of
the roof panel. Slide the other roof panel into position ensuring that the edge which enters the ridge beam
assembly is the edge with channels 27E & 27F attached. Fix the second roof panel to the ridge beam assembly
(from the inside of the shed) using 16mm self tapping screws. Fix the roof panels to the gable ends using
4 lip components (53) using 16mm self tapping screws. The screws must pass through the holes in all three
components i.e. lip (53), gable end & roof panel. At this stage, do not fix the 4 screws directly adjacent to the
centre of the gable ends. Refering to the instructions in the diagram below, fix 2 roof braces inside the shed
Original Language Version
© Jack Sealey Limited
GSS3030G
Issue: 1 - 28/08/14
Advertisement
