Technical Characteristics; Installation Instructions - AEG MCD4538E User Manual

39 www.aeg.com
Substitution of light bulb
18.1.
To substitute the light bulb, proceed as
follows:
1.
Disconnect the oven from the
power supply. Take the plug out of
the socket or switch off the oven's
power circuit.
2.
Unscrew and remove the glass
light cover (1).
3.
Remove the halogen light bulb (2).
Warning! The bulb may be very
hot.
4.
Fit a new G4/12V/10-20W halogen
bulb. Warning! Do not touch the
19.

TECHNICAL CHARACTERISTICS

Specifications
19.1.
AC Voltage
Power required
Grill power
Microwave output power
Microwave frequency
Exterior dimensions (WHD)
Interior dimensions (WHD)
Oven capacity
Weight
20.
Before installation
20.1.
Check that the input voltage indicated
on the rating plate is the same as the
voltage of the power outlet you are
going to use. The rating plate is
located on the front part of the cavity
and it is only visible after opening the
door.
If required by the National Electrical
Code (or Canadian Electrical Code),
this appliance must be installed on a
separate branch circuit.
Installer – show the owner the location
of the circuit breaker or fuse. Mark it
for easy reference.

INSTALLATION INSTRUCTIONS

light bulb surface directly with your
fingers because you may damage
the bulb. Follow the lamp
manufacturer's instructions.
5.
Screw the glass light cover into
place (1).
6.
Connect the oven again to the
power supply.
Before installing, turn power OFF at
the service panel. Lock service panel
to prevent power from being turned
ON accidentally.
Be sure your appliance is properly
installed and grounded by a qualified
technician. Installation,
connections and
comply with all applicable codes.
Open the oven door and take out all
the accessories
packing material.
Do not remove the mica cover on the
ceiling of the interior! This cover stops
(see rating plate)
3300 W
1500 W
1000 W
2450 MHz
595  455  472 mm
420  210  390 mm
38 ltr
32 kg
electrical
grounding must
and remove the