Warning Icons And Error Codes - Philips EP5315 User Manual

13 Remove and empty the container.
14 Clean the classic milk frother after descaling (see 'Weekly cleaning of classic milk frother and steam
wand ').
15 Clean the brew group (see 'Cleaning the brew group under the tap').
16 Install a new AquaClean filter in the water tank.
Tip: Using the AquaClean filter reduces the need for descaling!
What to do if the descaling procedure is interrupted
You can exit the descaling procedure by pressing the on/off button on the control panel. If the
descaling procedure is interrupted before it is completely finished, do the following:
1 Empty and rinse the water tank thoroughly.
2 Fill the water tank with fresh water up to the CALC CLEAN level indication and switch the machine
back on. The machine will heat up and perform an automatic rinsing cycle.
3 Before brewing any drinks, perform a manual rinsing cycle. To perform a manual rinsing cycle, first
dispense half a water tank of hot water and then brew 2 cups of pre-ground coffee without adding
ground coffee.
Note: If the descaling procedure was not completed, the machine will require another descaling
procedure as soon as possible.

Warning icons and error codes

Meaning of the warning icons
Fill the water tank with fresh
water to the MAX level
indication.
ADD WATER
The bean hopper is empty.
Put new coffee beans in the
bean hopper.
ADD COFFEE
The brew group is not in the
machine or it is not inserted
correctly. Insert the brew
group.
The coffee grounds container
is full. Make sure the machine
is switched on. Then remove
and empty the coffee
grounds container.
English
The brew group is blocked by
coffee powder. Clean the brew
group.
Insert the drip tray and close
the service door.
If the display shows an error
10
code, check section 'Meaning
of the error codes' to see what
the code on the display means
xx
and what you can do. The
machine cannot be used when
this icon is on the display.
There is air in the machine,
place a cup under the hot
water spout and select Ok to
start priming. Make sure the
hot water spout is inserted
before starting the process.
15