Philips EP5315 User Manual page 19

Problem
The frothed milk is too
cold.
The coffee is splashing.
The machine seems to
be leaking.
I cannot activate the
AquaClean filter and the
machine asks for
descaling.
The new water filter does
not fit.
The machine is making a
noise.
Cause
The machine circuit is blocked
by limescale.
The classic milk frother is dirty
or not assembled correctly.
The type of milk used is not
suitable for frothing.
The distance between cup and
spout is too large.
The machine uses water to
rinse the internal circuit and
brew group. Some water flows
through the internal system
directly into the drip tray.
The drip tray is too full and has
overflowed which makes it look
like the machine is leaking.
The machine is not placed on a
horizontal surface.
The filter has not been replaced
in time after the AquaClean
filter icon flashed and the
capacity dropped to 0%.
You did not install the
AquaClean filter during first
installation, but after having
brewed approx. 25 coffees
(based on 100ml cups). The
machine has to be completely
limescale-free before you
install the AquaClean filter.
You are trying to install another
filter than the AquaClean filter.
It is normal that your machine
makes noise during use.
Solution
Descale the machine.
Clean the classic milk frother and make
sure it is correctly assembled.
Different types of milk result in different
amounts of froth and different froth
qualities. We have tested the following
milk types which proved to deliver a
good milk froth result: semi-skimmed or
full-fat cow's milk, soy milk and lactose-
free milk. Other types of milk have not
been tested and may result in a small
amount of milk froth.
Place the espresso stand on the drip
tray, under the spout.
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray cover. Place the espresso stand
under the dispensing spout to collect
rinsing water.
Empty the drip tray when the 'drip tray
full' indicator pops up through the drip
tray cover. Place the espresso stand
under the dispensing spout to collect
rinsing water.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.
Descale your machine first and then
install the AquaClean filter.
First descale the machine and then
install a new AquaClean filter. After
descaling, the filter counter is reset to
0/8. Always confirm filter activation in
the machine menu. Also do this after
filter replacement.
Only the AquaClean filter fits into the
machine.
If the machine starts to make a different
kind of noise, clean the brew group and
lubricate it (see 'Lubricating the brew
group').
English
19