Installation - Siemens ADE5300 Installation Manual

Installation

6 Installation
8
Siemens AB
Security Products
Required tools & material

Medium-duty drill and associated drill-bits

4 mounting screws or standoffs (approx. 4 mm)

Flat-blade terminal screwdriver

Wire cutters

Cable strippers
Expected installation time
30 minutes
Mounting instructions
1. Remove the ADE5300 from its carton and discard the packaging material.
2. Place the ADE5300 (base plate) against the surface to which it is to be affixed
and mark the location of the mounting holes.
We recommend to mount the ADE5300 within a cabinet. Align the ADE5300
base plate with the holes located on the cabinet backplane and proceed to
step 3.
It is recommended that you affix the ADE5300 at all four of the mounting
locations provided.
Warning Do not apply power to the ADE5300 or associated components at this stage.
3. Select the appropriate drill bit according to the mounting surface / hole size
and drill the holes in the locations marked (if required).
4. Fasten the ADE5300 (base-plate) to the surface using the correct type of
screws or standoffs for the surface.
5. Connect the cabling to the ADE5300 PCB. See section 7.1: Connections.
6. Apply power to the ADE5300 and test its operation.
This step may require installation and programming of the access control host
software and download of the firmware instruction set.
Alternatively, the firmware and configuration may carried out using the FLN
Field Service Tool.
05.2015