PN-CD701 Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. Screw Driver Nipper 3. Dismantle Procedure This product can be dismantled by below steps.
PN-CD701 Dismantle Instruction Front USB PWB (1pcs) Wi-Fi module PWB (1pcs) Source LED PWB (4pcs) Win button + mic-array PWB (1pcs) Key PWB (1pcs) 6. Battery This model uses only CR2032 Lithium Coin battery on Pre scaler PWB. Battery CR2032 can easily be removed from the battery holder.
PN-CD701 Dismantle Instruction 7. LCD Module LCD Dismantle procedure Due to direct bonding technology the front glass cannot be removed from the LCD. After you have removed the PWB´s please take out the cables from the LCD module.
PN-CD701 Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB. These capacitors can be removed by using nipper to cut the leads.
PN-CD701 Dismantle Instruction 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below. Parts Note 70inch LCD module Printed Circuit Boards Power PWB LED driver PWB Pre scaler PWB Scaler PWB T-CON PWB Side IO PWB...