Advertisement
Front Panel Step 2: Program the DSR-6100.
If not there already, move the cursor to the upper left hand corner of any menu and
press ENTER to revert to the main "DSR-6100" menu:
Use the ▲▼ arrow buttons, if necessary, to access the MANUAL TUNE menu.
Use ◄ ► buttons to move the cursor to "Input" and press ENTER.
Press the ▲ arrow twice to change the value to "Port 3" and press ENTER.
Use ◄ ► buttons to move the cursor to "Xpndr" and press ENTER.
Press the ▲ arrow eight (8) times to change the value to "09" and press ENTER.
Use ◄ ► buttons to move the cursor to the left of "MANUAL TUNE".
Press the ▼ arrow button once to access the "MODULATION" menu.
Press the ▼ arrow button once to change DCII-AUTO to "DVB S2" mode and press
ENTER. Use ◄ ► buttons to move the cursor to "Symbol" and press ENTER.
If the default DVBS2 Symbol rate value is 01.000000 Msps, use the ◄ ► ▲▼ buttons
to change the "Symbol" rate value to 30.000000 Msps and press ENTER.
Confirm the green SIGNAL LED comes on. Use ◄ ► buttons to move the cursor to
the left of "MODULATION" and press the ▲ arrow one (1) time to "MANUAL TUNE".
move the cursor to "Xpndr" and press ENTER. Press the ▲ arrow five (5) times to change
Xpndr "09" to "14" and press ENTER. Confirm the green SIGNAL LED stays on.
Use ◄ ► buttons to move the cursor to "Input" and
press ENTER. Press the ▲ arrow once to change the
value to "Port 4" and press ENTER. Use ◄ ► buttons to
4
Use ◄ ► buttons to move
the cursor to "Install" and
press ENTER.
»
Port 3/Xpndr 9
»
Port 4/Xpndr 14
Use ◄ ► buttons to move
the cursor to the left of
"Mode" and press ENTER.
4
14
1170.00
Advertisement
